![]() ![]() The fault can be your output drivers- the MOSFETS/IC's fitted for both the channels, Use a meter after disconnecting to check for short in the drivers.ĭisconnect the positive and negative voltages to the output and see if the protect changes. It is possible that the amplifier had encountered a fault with a higher current drain which had triggered it to a protection fault condition. Try this first, if you could, could you take a picture of the windings at the back end of the generator, this will confirm for me what leads you have present. If you have voltage on the power output and not on the exciter, then the exciter is shot and your avr might not be. Through the following links, you can skip to the menu or to the main text in this page. If your generator has these exciter winding, you should check if you have voltage there with the 9 volts applied to the rotor. The two to the power output are voltage reference only. And, we haven't tried the manual transmission yet. Please see this post Click Here Please ask questions if you have them!! Kubota Transmission Question. This is the exciter winding and this supplies power to the avr for the rotating field. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |